volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

TNN32-01 > < Recall - Windshield Wiper Arm Replacement|Page 19756
Page 4
background image

Passenger side:

The distance from the center of the wiper blade to the upper edge of the trim strip must be 3.5 in. (90 mm).

Caution!

Hold the wiper arms in position when tightening the nuts.

Tighten the nuts to 16.2 lb ft (22 Nm) 

Angle torque 90°

Fit the protective covers.

If adjustment is necessary after checking function see note below

NOTE!!!

As described above when installing a "NEW" (never installed) wiper arm; torque to 16.2 lb ft (22 Nm) and then angle torque 90°.

As previously stated; For this recall new wiper arms are to be used! However if removing and reinstalling these arms for any reason at anytime
thereafter; torque to 16.2 lb ft (22 Nm) but DO NOT ANGLE TORQUE a previously installed wiper arm!

TNN32-01 > < Recall - Windshield Wiper Arm Replacement|Page 19756