Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Engine, Cooling and Exhaust > Engine > Actuators and Solenoids - Engine > Variable Valve Timing Actuator > Component Information > Locations > Page 3003

Page 5
background image

Install:

-

the trigger wheel

-

the camshaft position (CMP) sensor housing and a new cover

-

the intake air hose between the turbocharger (TC) and the air cleaner (ACL) cover

-

the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for motor bracket

-

the negative battery cable. First read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.

Checking the engine

Test drive the car to check the function of the engine.

Replacing the rear seal

The following components must be removed when replacing the rear seal:

-

the cross stay between the suspension turrets

-

the air hose from the air cleaner (ACL) to the turbocharger (TC). Place to one side. Seal the openings

-

place the air cleaner (ACL) cover to one side

-

the charge air pipe over the engine. Seal the openings

-

the cover over the ignition coils

-

the upper torque rod bracket

-

the camshaft position sensor (CMP) housing and trigger wheel.

Replacing the rear camshaft seal

Engine, Cooling and Exhaust > Engine > Actuators and Solenoids - Engine > Variable Valve Timing Actuator > Component Information > Locations > Page 3003

[PREV PAGE] [NEXT PAGE]