Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 6
background image

Visually check the bearing shells.
If in doubt measure out-of-round. Use a bore gauge.
For the correct diameter of the bearing recess, see Specifications, mechanical See: Powertrain Management/Computers and Control Systems/Engine
Control Module/Specifications.

Checking the connecting rod in a connecting rod aligner

Check for out-of-true and twisting.

Caution! Check that the aligner fork is not burred and round at the handle. Remove and apply the expander at the big end between each
alignment operation.

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Crankshaft, Engine > Component Information > Service and Repair > Crank Mechanism, Measuring > Page 3099

< PREV PAGE NEXT PAGE >