Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Engine, Cooling and Exhaust > Engine > Timing Components > Timing Belt > Component Information > Service and Repair > Removal and Replacement > Page 3398

Page 5
background image

The thermostat can be tested in warm water.
Maximum opening must occur within 2 minutes in water at opening temperature.
Marking.90° C
Starts to open at.90°C
Fully open at.105°C

Belt Transmission, Assembly

Belt transmission, assembly

Special tools:

999 5747 Socket See: Tools and Equipment/999 5747 Socket 

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.

Tightening torque

For tightening torques not in the text, see Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.

Installing the water pump

Install the rear timing cover.
Screw into place at the three mounting points.
Install the water pump with a new gasket.
Apply thread sealant, P/N 11-61 056, to all the screws for the water pump. Tighten crosswise.

Installing the oil pump

Use a new gasket and a new O-ring around the oil pump housing.
Screw sliding sleeve 999 5747 into place at the front of the crankshaft journal.
Press in the pump over the sliding sleeve.

Engine, Cooling and Exhaust > Engine > Timing Components > Timing Belt > Component Information > Service and Repair > Removal and Replacement > Page 3398

[PREV PAGE] [NEXT PAGE]