XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Glove Box Lamp: Testing and Inspection
Check Hazard Warning Signal Flasher and Glove Compartment Lighting
Check hazard warning signal flasher and glove compartment lighting
Checking the cable
-
Ignition off.
Check the cable between the central electronic module (CEM) terminal #17D and the hazard warning signal flasher switch terminal #1 (3/6). Check for a
short-circuit to supply voltage. Check for an open-circuit.
Remedy as necessary.
If no faults were found, replace the switch.
Other information:
-
For information about the central electronic module (CEM) connector, see Central electronic module (CEM), replacing See: Body and
Frame/Body Control Systems/Body Control Module/Service and Repair
-
To connect the breakout box, see Connecting the breakout box See: Body and Frame/Body Control Systems/Testing and Inspection/Pinout Values
and Diagnostic Parameters/Connecting the Breakout Box/Connecting the Breakout Box, Central Electronic Module (CEM)
-
For information about signals, see Signal specification See: Body and Frame/Body Control Systems/Testing and Inspection/Pinout Values and
Diagnostic Parameters/Signal Specification
-
To replace the switch for the hazard warning signal flasher, see Switch hazard warning signal flasher, replacing See: Hazard Warning
Lamps/Hazard Warning Switch/Service and Repair
-
Checking wiring and terminals See: Testing and Inspection/Component Tests and General Diagnostics/Checking Wiring and Terminals.