Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Maintenance > Fuses and Circuit Breakers > Fuse Block > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 2825

Page 4
background image

Remove all relays and shunts bridged to the control module. Note the locations.

Release the catch on the rear. Use a screwdriver.
Lift and pull out the control module.

Check

Check that the control module's connectors are intact.

Installing the control module

-

Press the control module into place so that the catch on the rear engages

-

Position the connector. Carefully press the connector down.

Note! The pins are fragile. Check that the connector goes straight down into the control module.

-

Tighten the screw for the connector

-

Check that the connector cover is correctly positioned. Remedy if necessary

-

Install the relays and shunts. Note their locations

-

Install the integrated relay/fusebox. See Installing the integrated relay/fusebox in the cargo compartment.

Ordering software

Order applicable software.  See: Testing and Inspection/Programming and Relearning

Maintenance > Fuses and Circuit Breakers > Fuse Block > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 2825

[PREV PAGE] [NEXT PAGE]