Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 4984

Page 20
background image

Passenger Door Module (PDM)

Passenger door module (PDM), replacing

Preparations

Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
which is required to order the correct software.

Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the
cause of the fault.

Removing the passenger door module (PDM)

Ignition off.

Remove:

-

the door panel, see Replacing the front door side panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service
and Repair.

-

the nut and screw holding the control module in place

-

the connectors.

Grasp the underneath of the control module. Press upwards. Carefully pull the module from the lower catches.

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 4984

[PREV PAGE] [NEXT PAGE]