XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Fill in the two markings on the headlining using a pencil so that they are easier to see.
Do not use a ball point or permanent marker pen. These can discolor the headlining.
Installing the mass movement sensor
Place double-sided adhesive tape on the underside of the mass movement sensor. Position a 9 mm drill bit as a spacer along the edge. Install the mass
movement sensor exactly according to the markings on the headlining. Press into place for approximately 15 seconds.
Connect the connector.
Note the bulge on the left hand side of the mass movement sensor and the position of the drill. It is important that the position of the mass movement
sensor is correct.
Remove the drill bit.
Installing the foil tape
Mark the center of the foil tape and the mass movement sensor. Remove the backing paper at one corner of the foil tape.