XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
4. S40 (-04)/V40.
1 - car model S40 (04-)/V50
2 - car model V70 (00-), V70 XC (01-)/XC70, S60, S80 and XC90
3 - car model V70 (-00), V70 XC and S70/C70
4 - Checking communication errors car model S40 (-04)/V40
Checking communication errors, car model S40 (04-)/V50
Hint: Test the communication with another corresponding vehicle to decide if the malfunction is in the vehicle or in VIDA/VCT/cable harness. If the
communication works on another vehicle, the malfunction is in the vehicle.
Hint: For current information about each circuit and signals, see wiring diagram and signal description for each system.
Check the voltage feed to diagnostic outlet #16. The voltage shall match battery voltage.
Check the cable for power ground and signal ground to diagnostic outlet #4 and #5.
Hint: When VCT2000 is connected to the diagnostic outlet (is supplied with voltage), the indicator diode shall be activated with a green light. Then the
indicator diode flashes quickly when communication takes place with a control module. In case of certain internal malfunctions on VCT2000 the
indicator diode is activated with a red light!
For communication problems with control units on the high-speed network, check communication cables between diagnostic outlet #6/#14 and
central electronic module (CEM) #B11/#B12 for open circuit, short-circuit to ground and short-circuit to voltage according to references above.
For communication problems with control units on the low-speed network, check communication cables between diagnostic outlet #3/#11 and
central electronic module (CEM) #B16/#B15 for open circuit, short-circuit to ground and short-circuit to voltage according to references above.
Also check the communication cables for the low and high-speed net between the central electronic module (CEM) and the other connected
control modules according to troubleshooting above.
Check that the control module's voltage feed and ground connection are trouble-free.
Caution! If none of the above checks help, try reading out diagnostic trouble codes in the central electronic module (CEM). Done via VIDA
vehicle communication. A prerequisite for being able to communicate with the control modules in the vehicle is that the central electronic
module (CEM) is active and can be communicated with. If communication is not possible with the central electronic module (CEM), check the
voltage feed and ground for the central electronic module (CEM).
VCT2000 and cable harness
Connect VCT2000 to the vehicle so that it is supplied with voltage. Test VCT2000 by selecting the system's self-test and VCT Test in the VIDA
main menu. If any malfunction is found according to the test, first replace the cable harness then the VCT2000, if the test still indicates a
If no malfunctions were found after troubleshooting according to above, try with a new cable harness and/or new VCT2000.
If no malfunctions were found after troubleshooting according to above, try performing a complete system reset of VIDA.
Checking wiring and terminals See: Testing and Inspection/Component Tests and General Diagnostics/Checking Wiring and Terminals