Central Electrical Unit Engine Compartment (Relay Box) (page 12 of 16)

Detach the bottom section from its mounting by the spring strut housing by pressing it in towards the engine compartment.

Installation

Note! For tightening torques, see Specifications See: Specifications/Mechanical Specifications/Starting and Charging/System Specifications.

Installing the bottom section

Install:

-

bottom section

-

the screws

-

the air cleaner (ACL) housing.

Installing the relay/fuse holder

Install:

-

the cable terminals for the main terminals

-

the relay/fuse holder. Check that the rubber seals are correctly positioned

-

the screws as illustrated. Tighten screw 4. Tighten to 2 Nm

-

the battery leads

-

the nut for the battery leads.

Finishing work

Install:

-

the cover for the fusebox

-

the battery negative pole. Tighten according to Tightening torque See: Specifications/Mechanical Specifications/Starting and Charging/System
Specifications. Also see Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.