XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
Install a 15A fuse in position 9 in REM.
-
Locate the 14-pin connector (1) in the left-hand corner of the roof above the D-post
-
Disconnect the clip for the connector from the roof by pulling the connector straight down from the roof
-
Separate the connector.
-
Disconnect the cable pin (1) in position 8 in the female terminal. Lift the red catches on the connector and press out the entire red plastic insert
-
Using a thin, pointed object, press the catch holding the cable pin to one side. Pull out the cable at the same time.
-
Connect the pin (1) that has just been disconnected to the 2-pin connector from the kit in position 1. (Use the same method as for the 14-pin
connector)
-
Connect the remaining cable (2) from the 2-pin connector for the adapter cable to position 8 in the 14-pin female terminal from the car. This final
connection reconnects the power to the position from where the pin was previously removed
-
Reinstall the plastic catches on the connectors
-
Connect both connectors to the corresponding connectors
-
Reinstall the 14-pin connector at the roof using the clip.
-
Clamp the adapter cable to the existing cable harness at regular intervals
-
Clamp at the points where the existing cable harness is secured in the car with clips.