volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

NEXT PAGE > < PREV PAGE
Page 3
background image

B.

DTC: BCM 0127 / C111464 - Angle of lean sensor. Signal outside its permitted range

These DTC's can be set while driving in rather sharp curve at an angle, usually at 20 mph (30 kph) at low engine load, while the steering wheel is
held at the same position throughout the curve.

If these DTC's are seen: Perform a BCM software upgrade.

Note!

For MY 05, replace the BCM as well as perform a BCM upgrade.

Brakes and Traction Control > Antilock Brakes / Traction Control Systems > Acceleration/Deceleration Sensor > Component Information > Technical Service Bulletins > ABS/TCS - Sensor Cluster DTC Diagnosis > Page 13007

NEXT PAGE > < PREV PAGE