XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
The amount of steps is then used to determine which function the DMM has in the system (see reference table shown). The CCM will then reprogram the
DMM with the ID corresponding to that function.
What is done during the calibration?
The Calibration checks the configuration of the LIN bus 1 and LIN bus 2. The CCM checks the presence of the Damper Motor Modules, Seat heat
modules (option) and Air Quality Sensor (option). The range for each DMM is also checked to ensure that they are within specification.
Hint for fault tracing:
Reading out the actual ranges between upper and lower end positions measured by the DMM's (see reference table) can be helpful during fault tracing.
In VADIS, go to "Information Manager/Group 8/Diagnostic Information/Diagnostic trouble codes and associated procedures. Select group 87, climate
units, and open the DTC CCM-0071 - Damper motor, faulty position. Click on the VCT symbol to proceed to reading out the actual range per DMM.
If you would run into a range of 0 or 4095, there may be an identification problem. Try to re-identify before continuing with fault tracing.
Warranty Information
