volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 4589 > < Procedures|Page 4587
Page 1
background image

Fluid - A/T: Removal and Replacement

Transmission fluid, replacing

Warning! Avoid skin contact with the transmission fluid.

Note! Use only transmission oil, Volvo P/N 116 1540-8 (1 liter container), 116 1640-6 (4 liter container).

Conditions

The oil should be replaced only in the two following instances:

Where diagnostic trouble codes (DTCs) TCM 0042 and TCM 0046 are stored, in which case the diagnostic function activates the warning lamp in the
following circumstances.
The transmission control module (TCM) receives data about the operating temperature of the transmission fluid while the car is being driven. TCM 0042
is stored after an accumulated amount of time.
Diagnostic trouble code (DTC) TCM 0046 is stored if the transmission fluid temperature exceeds 150° C for more than two minutes.
In cars used in continuous taxi service or used for towing a trailer or caravan for most of its mileage, the oil must be replaced at a service interval of 75,
000 km ± 5000 km. This is to conform to the regular service program.

Warning! The oil may be very hot if the car has just been driven. Avoid skin contact.

Draining

Remove:

-

the splash guard under the engine

-

the oil plug. Drain the transmission oil.

Installing the oil plug

Use a new gasket.
Tighten the plug. Tighten to 40 Nm.
Install the protective cover.

Draining oil

Procedures|Page 4589 > < Procedures|Page 4587