XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Install the lock bracket (2).
Tighten the screw (1).
Note! There may be a gap (3) of a few millimetres between the pipe coupling and the power steering pump. Bend the bracket so that the twelve
edged mounting on the bracket is on the nut.
Install:
-
the auxiliaries belt. Use999 7109 Wrench See: Tools and Equipment/999 7109 Wrench
-
the connector with holder on the power steering pump
-
the servo reservoir in its mounting on the expansion tank
-
the hoses in their holders and clips
-
the tie strap for the servo hose at the suspension turret.
Install:
-
the charge air hose on the charge air cooler (CAC)
-
the screw for the charge air pipe above the engine and clamp for power steering pump delivery lines from the intake manifold
-
cold air inlet hose to the control module.
Check the level in the servo reservoir and top up if necessary.
Connect the negative battery lead. Refer to: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting