XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Control Module: Service and Repair
Transmission control module (TCM), replacing
Points to observe when replacing the control module
Caution! Software can only be ordered when the control module is installed in the vehicle. VIDA reads off the new control module identity
which is required to order the correct software.
Caution! Wait two minutes after the ignition has been switched off. The main relay must be voltage-free before the control module can be
removed from the car. If the engine cooling fan runs on after the ignition has been switched off, wait until it stops. Then wait another two
minutes.
Caution! Always check that the control module and control module box connector pins and sleeves are not bent or damaged. This may have
caused the fault.
Preparations for replacement
Remove:
-
the cable from the battery negative terminal. See Battery, disconnecting See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting
-
the cover over the control module.
Removing the control module