XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Repairs and Inspections Required After a Collision: Service and Repair
After A Collision In Which the SRS System Has Been Deployed
After A Collision In Which The SRS System Has Been Deployed
NOTE: First read the instructions for reusing the safety products according Supplemental Restraint System (SRS), Reuse.
The following components must always be replaced:
-
Steering wheel module.
-
Passenger module (if applicable).
-
Steering wheel.
-
Contact Reel.
-
Sensor module (see separate instructions below).
-
Seat belt assembly (including the seat belt buckle on both sides).
-
The SRS ignition cable for the passenger module (if applicable).
The following components must be inspected and replaced if damaged:
-
The windshield and its bonding.
NOTE:
-
Must be PUR sealed if replaced. Carefully remove any glass splinters. Remember to check in the ventilation ducts.
-
The instrument panel must be replaced if the passenger air bag module has been activated.
WARNING: US models only: The brackets must be replaced if the dashboard or the lower panel on the driver's side has been damaged.
Replaced brackets must be tightened. Tighten to 25 Nm.
-
The dashboard and its frame (if applicable).
-
Panels under the dashboard.
-
Loudspeakers (in the dashboard).
CAUTION:
-
The sensor module must always be replaced if:
-
Diagnostic trouble code (DTC) SRS-112 or SRS-0001 is stored.
-
The diagnostic trouble code (DTC) cannot be erased when the car has been repaired, there is still a fault in the sensor module.
-
The sensor module is mechanically damaged.
-
There is mechanical damage to the floor of the car around the sensor module. This could weaken the mechanical mountings for the
sensor module. Remove the sensor module. Check that its mountings are not cracked.
-
While under warranty, diagnostic trouble code (DTC) SRS-112 or SRS 0001 must not be erased. Instead the sensor unit should be
returned to Volvo according to current procedures.
