Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)

Sensors and Switches > Sensors and Switches - Cooling System > Engine - Coolant Temperature Sensor/Switch > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Service and Repair > Temperature and Pressure Sensors, Replacing > Page 3078

Page 5
background image

Caution! Check that no pins or sockets are damaged on the connector.

Install the surround for the control module box.
Carefully press the control module down into the grooves on the inside of the control module box. Press to the limit position
Insert tool 999 5722 Wrench See: Tools and Equipment/999 5722 Wrench around the control module.
Move the upper section of the tool forwards as far as it will go. Pull up the tool.
Press the cover into place over the control modules. Check that the air ducts are correctly positioned.

Finishing

Remove the hose clip. Refill with coolant. Use filling equipment 951 2957 Coolant Reservoir See: Tools and Equipment/951 2957 Coolant Reservoir
and cover 951 2953 Cover See: Tools and Equipment/951 2953 Cover. Install the cap on the expansion tank.
Test drive the engine until the thermostat has opened. Check for leakage. Top-up the coolant.

Sensors and Switches > Sensors and Switches - Cooling System > Engine - Coolant Temperature Sensor/Switch > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Service and Repair > Temperature and Pressure Sensors, Replacing > Page 3078

[PREV PAGE] [NEXT PAGE]