Volvo Workshop Manuals
XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Sensors and Switches > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - A/T > Transmission Position Switch/Sensor, A/T > Component Information > Locations > Page 3985
the screws from the bracket for the gear selector cable
the cable from the lever. Use special tool 999 7077 Jimmy bar See: Tools and Equipment/999 7077 Jimmy Bar.
Move the cable to one side.
Checking the setting
Note! When adjusting the gear-shift position sensor, press the tool down to the flat surfaces below the thread on the shaft.
Remove the lever. Install adjustment tool 999 5475 GAUGE See: Tools and Equipment/999 5475 Gauge on the gear shift linkage rod. Check that the
Note! For tightening torques, see See: Specifications/Mechanical Specifications/Automatic Transmission/Transaxle/System Specifications/Tightening
Adjusting gear-shift position sensor
Slacken off the screws for the gear-shift position sensor.
Installing the lever and gear selector cable
|[PREV PAGE] [NEXT PAGE]|