XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Lubricate the O-rings for the cable harness grommet and the oil temperature sensor with automatic gearbox fluid.
Install:
-
the cable harness. Connect the connectors to the solenoids
-
the oil temperature sensor with the holder and screw. Tighten to 10 Nm
-
the cable harness on the holder. Check that the cable harness is correctly positioned.
Sealing the cover
Check that the mating surface for the cover is level.
Wipe the cleaned mating surfaces on the cover and gearbox. Use methylated spirit.
Note! Ensure that no dirt gets into the gearbox.
Apply a bead of sealing compound, approximately 3 mm thick, to the cover. P/N 1161409-6. Apply the compound around the screw holes.
Installing the control system cover
Reinstall the control system cover on the gearbox. Tighten the screws alternately. Tighten to 12 Nm. Torx TX 40.
Install:
-
the oil pipe on the gearbox with a new O-ring