Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 3
background image

Place the sealing plate in the control module
Press the throttle valve and the temperature/pressure sensor into place on the control module connector. Place the cupped washer with the convex side
against the temperature/pressure sensor.
Lubricate the sealing rings on the valves. Use oil. See: See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Specifications

Installing the O-ring

Carefully check that the control module sealing surface and the valve seats in the Active on Demand Coupling (AOC) are clean, there must be no residue
left from cloths or paper.
Lubricate the new O-ring using oil. See: See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Specifications and securely press into its
seat.

Installing the Active on Demand Coupling (AOC)

Install the control module with the valves for the coupling, hold it pressed against the coupling housing while installing the 2 x screws. Lightly tighten
alternately.

Sensors and Switches > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - Differential > Differential Temperature Sensor/Switch > Component Information > Service and Repair > Page 4013

< PREV PAGE NEXT PAGE >