XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Use 999 7190 Drift See: Tools and Equipment/999 7190 Drift , extend if necessary using 999 1801 STANDARD SHAFT See: Tools and
Equipment/999 1801 Standard Shaft.
Finishing
Checking the oil level in the bevel gear
Check the oil level in the bevel gear. Refer to: Replacing the pinion seal for the bevel gear, TF-80SC AWD See: Replacing the Pinion Seal for the Bevel
Gear.
Install the right driveshaft. Refer to: Drive shaft right, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing.
Sealing Ring, Crown Wheel Shaft, Left-Hand Side, Replace
Sealing ring, crown wheel shaft, left-hand side, replace
Special tools:
999 7086 Puller See: Tools and Equipment/999 7086 Puller
999 7087 Drift See: Tools and Equipment/999 7087 Drift
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Preparatory work
Removing bevel gear
Remove the bevel gear. See See: Service and Repair/Removal and Replacement/Automatic Transmission Components/Bevel Gear
Removal
Removing the sealing ring
Position the bevel gear on a workbench. Support the gear using a wooden block.
Use extractor 999 7086 Puller See: Tools and Equipment/999 7086 Puller together with spacer ring 7086-1. Knock the seal towards the housing using