XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Tap in the seals to the correct depth between the drift and the final drive housing.
Note! There are different depths for the left and right-hand sides between the flange of the drift and the final drive housing.
Left side: the measurement (A) must be 0.5 mm; measured from the surface of the hooks on the nut.
Right-hand side: the dimension (B) must be 6 mm. The seal must be flush with the housing surface.
Installing the drive shaft
To install drive shafts, see Drive shaft rear, replacing See: Axle Shaft Assembly/Service and Repair/Drive Shaft Rear, Replacing.
Filling and checking the oil level
Top up and check the oil level in the final drive. See See: Differential Assembly/Service and Repair/Final Drive, Replacing.
Seal CV Joint Housing, Replacing
Seal CV joint housing, replacing
Removal
Preparatory work
Remove the right-hand drive shaft. See: Drive shaft right, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Axle Shaft
Assembly/Service and Repair/Drive Shaft Right, Replacing. Remove the left-hand drive shaft. See: Drive shaft left, replacing, TF-80SC AWD, B6324S,
TF-80SC, B6324S, TF-80SC AWD See: Axle Shaft Assembly/Service and Repair/Drive Shaft Left, Replacing.
Removing the sealing ring for the CV joint housing from the stub axle
