XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Position locating pin 5779-1 in the end of the differential. Lubricate the sealing ring lip and the locating pin using ATF oil. Tap in the seal using drift 999
5779 Drift See: Tools and Equipment/999 5779 Drift. Tap the drift in until it is contact with the end of the connecting sleeve.
Install the circlip for the connecting socket.
Finishing
Install the bevel gear according to Bevel gear, replacing See: Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Components/Bevel Gear
Check the gearbox oil level according to Oil level, checking See: Automatic Transmission/Transaxle/Service and Repair/Procedures/Oil Level, Checking
Sealing Ring Drive Shaft/Differential, Replacing
Sealing ring drive shaft/differential, replacing
Special tools:
999 5768 Puller See: Tools and Equipment/999 5768 Puller
999 5769 Pilot See: Tools and Equipment/999 5769 Pilot
999 5770 Drift See: Tools and Equipment/999 5770 Drift
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Removal
Preparations
Remove the left drive shaft according to: Drive shaft left, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Axle Shaft
Assembly/Service and Repair/Drive Shaft Left, Replacing.
Removing the seal ring
Remove:
-
the metal ring. Use a small screwdriver
-
the sealing ring. Use: 999 5768 Puller See: Tools and Equipment/999 5768 Puller.