XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Install the sealing ring for the adjustment nut.
Lubricate the sealing ring lip using wheel bearing grease, P/N 116 1241-3.
Use drift 999 5655 Punch See: Tools and Equipment/999 5655 Punch. Tap in the seal until the drift bottoms on its stop against the nut.
Install a new O-ring on the nut. Lubricate the O-ring and threads with wheel bearing grease as above.
Installing the adjustment nut
Install the adjustment nut.
Use wrench 999 5371 NUTS-DIFF.BEARING) 1035 See: Tools and Equipment/999 5371 Nuts-Diff. Bearing 1035 Turn the propeller shaft when the
nut is tightened to its previously measured position.
Checking the marking
Check that the marking corresponds exactly. Check the height. See Marking the position of the adjustment nut.
Install the split pin. Tighten the screw. Tighten to 50 Nm.
Checking the oil level in the bevel gear
Check the oil level in the bevel gear. See Replacing the pinion seal for the bevel gear See: Automatic Transmission/Transaxle/Seals and Gaskets/Service
and Repair/Replacing the Pinion Seal for the Bevel Gear
Note! To install the drive shaft, see Replacing the front right drive shaft See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
