XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)
Screw sliding sleeve 999 5747 Socket See: Tools and Equipment/999 5747 Socket into place at the front of the crankshaft journal.
Press in the pump over the sliding sleeve.
Apply thread sealant, P/N 11-61 056 to all the screws for the oil pump.
Install the screws as a guide.
Carefully tap in the oil pump with a rubber mallet.
Tighten the oil pump crosswise.
Remove the sliding sleeve 999 5747.
Install the fuel delivery line.
Installing the crankshaft timing gear pulley
Note! The timing gear pulley can only be installed in one position at the splines on the crankshaft journal (see the illustration).
Carefully tap in the timing gear pulley with a rubber mallet.
Installing the idler pulley and belt tensioner
Install
-
idler pulley. Tighten
-
the tensioner damping unit.
-
the belt tensioner and the center screw. Ensure that the tensioner fork is centered over the cylinder block rib. Do not tighten
-
the lower belt guard at the oil pump
-
the fuel delivery line.
Checking and adjusting the variable valve timing unit
Check and adjust the variable valve timing unit. See: Variable valve timing unit, checking and adjusting See: Engine, Cooling and
Exhaust/Engine/Actuators and Solenoids - Engine/Variable Valve Timing Actuator/Testing and Inspection.
Installing the vibration damper
Install
-
the crankshaft pulley for the auxiliaries belt
-
counterhold 999 5433 COUNTERHOLD See: Tools and Equipment/999 5433 Counterhold.
-
the crankshaft center nut. Tighten to 300 Nm.