Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 AWD L6-2.9L Turbo VIN 91 B6294T (2004)

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Parking Assist Distance Sensor > Component Information > Service and Repair > Back-Up (Reversing) Warning Sensor (Parking Assistance Module (PAM)), Replacing > Page 1627

Page 8
background image

-

Place the bumper on a suitable underlay

-

Clean the outside of the bumper

-

Install the protective paper evenly distributed over the bumper.

Note! The paper protects the bumper and must be left in place throughout the operation.

-

Release the ten catches in the upper edge (1) of the bumper. Release the seven catches in the centre (2) of the bumper

-

Detach the two stays (3) from the lower edge of the bumper cover. Remove the rear section and the foam rubber from the bumper cover.

-

If necessary, clean the inside of the bumper cover to locate the four markings where the holes for the sensor holders will be drilled

-

Pre-drill the holes. Use a 3 mm (1/8") diameter drill bit. Drill out the holes. Use a 12.5 mm (1/2") diameter drill bit.

Note! Ensure that the drill is horizontal when drilling.

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Parking Assist Distance Sensor > Component Information > Service and Repair > Back-Up (Reversing) Warning Sensor (Parking Assistance Module (PAM)), Replacing > Page 1627

[PREV PAGE] [NEXT PAGE]