volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

Caution! Tighten to the correct torque. If the knock sensor is over-tightened it may deform. If it is too loose it may disrupt the function of the
sensor.

-

Install the new sensors using the screws in the cylinder block

-

Route the cables on the outside of the starter motor bracket

-

Align the sensor (looking from the front towards the rear)

-

The cable from the sensor for cylinder 3 = 3 o'clock and from the sensor for cylinder 5 = 6 o'clock. Tighten the knock sensors. See Tightening
torque, B6324S See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque.

Press the knock sensor (KS) connectors together. Check that the wiring is in the correct position. Use a clamp if necessary.

Install:

-

the intake manifold. See Intake manifold/gasket, replacing See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair 

-

the battery lead. First read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Knock Sensor > Component Information > Locations > Page 2162

< PREV PAGE NEXT PAGE >