XC90 AWD L6-3.2L VIN 98 B6324S (2007)
-
Carefully loosen the secondary catch of the black 6-pin connector using a small screwdriver.
-
Connect the red (R) cable from the timer relay to terminal 3, and the black (BK) cable to terminal 6 in the 6-pin connector.
-
Press the secondary catch together on the connector.
Synchronizing the Transmitter - Receiver
1. Connect the battery's negative lead.
2. Install batteries in the transmitter battery compartment.
3. Connect the connector and antenna cable to the receiver unit.
4. Within 5 seconds, press the "OFF" button on the transmitter until the LED goes out. Synchronization has been carried out.
-
Press the receiver unit onto the Velcro on the body plate if it has loosened.
-
Tape up any cable excess from the timer relay and place it next to the receiver unit under the insulation mat.