XC90 AWD L6-3.2L VIN 98 B6324S (2007)
Clean the surfaces of the sensors illustrated. Use isopropanol.
Allow to dry.
Apply a thin and even coat of activator on the cleaned surfaces and allow to dry for a minimum of 10 minutes and a maximum of 30 minutes
Paint the sensors with the same color code as the car. Use paint recommended by Volvo. Paint max. two layers (1 layer base coat and 1 layer clear
coat). Protect connections so that paint does not end up on the contact surfaces.
Caution! Too many layers of paint may result in partial or complete malfunction.
When the paint has dried, reinstall the sealing rings.
Turn the ignition switch to position 0.
Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.