XC90 AWD L6-3.2L VIN 98 B6324S (2007)
Disconnect the connector for the sensor.
Disconnect the cable duct from the torque rod bracket by carefully prying it off.
Replacing sensor cable, right-hand side
Pull up the sensor together with the cable duct so that the new sensor connector can be connected.
the tape. Connect the connector
the old sensor cable from the cable duct.
the new sensor cable in the cable duct. Use a new tie strap
the cable duct on the torque rod bracket.
Removing the air cleaner (ACL) housing, left-hand side
Remove the air cleaner (ACL) housing.