XC90 AWD L6-3.2L VIN 98 B6324S (2007)
Use 999 7190 Drift See: Tools and Equipment/999 7190 Drift , extend if necessary using 999 1801 STANDARD SHAFT See: Tools and
Equipment/999 1801 Standard Shaft.
Finishing
Checking the oil level in the bevel gear
Check the oil level in the bevel gear.
Install the right driveshaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing
Sealing Ring, Bevel Gear, Left
Sealing ring, bevel gear, left
Operation number: 43335-2
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal
Removing bevel gear
Remove the bevel gear. Refer to: Bevel gear, TF-80SC AWD See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear.
999 7086 Puller See: Tools and Equipment/999 7086 Puller.
Note! Check thoroughly that no seal residue remains.