XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Central Control Module: Customer Interest
Antitheft - No Start/DTC's CEM-6C48 or CEM-6C49
S80, XC90, V70, XC70, S60
No Crank No Start: CEM-6C48, CEM-6C49, ECM-710B, ECM-720A, ECM-P160200, ECM-U014100
This TNN covers two related concerns with different affected chassis ranges.
MY 2005: DTC CEM-6C48, CEM-6C49
The customer may experience a no crank no start condition (starter motor not activated. An error message saying "Start prohibited, try again" will
be displayed in the Driver Information Module (DIM) display and Diagnostic Trouble Codes (DTC) CEM-6C48 or CEM-6C49 will be stored in
the Central Electronic Module (CEM). The engine will usually not start even after several attempts.
If DTC ECM-710B, ECM-720A, ECM-P160200 or ECM-U014100 is set in the Engine Control Module (ECM), please refer to 2) below.
MY2005 - 2006: CEM-6C48 + ECM-710B, ECM-720A, ECM-P160200, ECM-U014100
The CEM may lose its EPROM memory. When this condition occurs, it will not be possible to start the car, since all security codes are lost
including the Immobilizer PIN codes.
Turbo engines: ECM-710B, CEM-6C48
Normally aspirated engines except V8: ECM-720A, CEM-6C48
Normally aspirated V8 engines: ECM-P160200, ECM-U014100, CEM-6C48