Volvo Workshop Manuals
XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1459
Check that the control module's connectors are intact.
Installing the control module
This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM).
Position the door module in the hole on the door panel.
Check that the lower mounting for the door module is correctly located in the support on the door panel
Press the door module into place
Connect the connectors
Install the nut and screw
Install the door panel.
Order software for the driver door module (DDM) according to the table below.
Order software for the passenger door module (PDM) according to the table below.
Initialize the window position in the communication input
Removing the upper panel
|[PREV PAGE] [NEXT PAGE]|