Volvo Workshop Manuals
XC90 AWD V8-4.4L VIN 85 B8444S (2005)
Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1492
the control module by lifting the catches at the upper edge and angle out
Note! Always check that the terminals or pins/sockets of the control module and control module box connectors are not bent or damaged. This
Hint: For the location of relays, see: See: Power and Ground Distribution/Locations
The wiring diagram for the relevant model year
Decals at both the integrated relay box and fusebox in the car
The Pocket Data book
The Owner's manual.
Installing the rear electronic module (REM)
Caution! The pins are fragile. Check that the connector enters straight down into the control module.
the control module in the bracket groove. Press the control module into place.
Installing the left cargo compartment side panel
Install the left-hand side panel in the cargo compartment. See: Side panel cargo compartment, replacement See: Body and Frame/Interior Moulding /
Caution! New software can only be ordered when the new control module is installed in the vehicle. The new control module identity is read off
|[PREV PAGE] [NEXT PAGE]|