volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

Remove:

-

the connectors, x2

-

the bolts, x4

-

the Engine Control Module (ECM).

Installation

Installing the Engine Control Module (ECM)

Note! Ensure that the rubber seal is positioned correctly in its groove.

Install:

-

the Engine Control Module (ECM)

-

the bolts, x4

-

the connectors, x2

-

the cover

-

the battery's negative cable in accordance with: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.

Ordering software

Order the software in accordance with: See: Testing and Inspection/Programming and Relearning/Software Downloading.

Finishing

Check that no diagnostic trouble codes (DTC) have been stored in the control module during the repair.
Test drive the vehicle and check the function of the engine.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Testing and Inspection > Page 1799

< PREV PAGE NEXT PAGE >