Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 AWD V8-4.4L VIN 85 B8444S (2005)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Locations > Page 2043

Page 5
background image

Fold up the carpet. Detach the sill trim panel slightly.
Carefully lift up the insulation block and place a block under the insulation block to access the module.
Install the new module and connect the cable connector.
Remove the block and fold the carpet back. Press the sill trim panel into place.

Installation

Vehicles with fuel pump driver module originally located in the right-hand rear wheel housing

Install two rubber plugs for the wheel housing.

Use: Plug, 974688

Install the inner fender with plastic nuts and rivets
Install wheel. Refer to: Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair 

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Locations > Page 2043

[PREV PAGE] [NEXT PAGE]