XC90 AWD V8-4.4L VIN 85 B8444S (2005)
the 2 screws (1)
the inlet hose
the hose clamp (2)
the connector (3)
the tie strap for the cable.
Remove the turbocharger (TC) control valve from the air cleaner (ACL) housing
the plastic nut on the wheel arch side
the air cleaner (ACL) housing.
Replacing sensor cable, left-hand side
Insert a hand under the fuse box. Disconnect the cable from the clips on the brake cable.
Pull up the sensor until the connector for the new cable is up.
Remove the tape and connect the connector.
Install the cable in the clips on the brake cable.
Caution! The yellow markings on the cables must be in the clip.
Raise the car.
Note! For tightening torques, see Specifications See: Brakes and Traction Control/Specifications/Tightening Torque.
Installing the sensor and the cable