volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

Note! There is a guide sleeve on the upper mounting for the plate. This must be lifted slightly so that the panel can be slid forward.

Remove the 6 screws.
Lift and slide the protective plate forward.
Remove the protective plate.

Draining coolant

Open the cock on the lower left edge of the radiator.
Drain the coolant into a clean receptacle.
Close the cock.

Installing the protective plate

Install:

-

the protective plate

-

the 6 screws; tighten.

Removing connectors

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Locations > Page 3804

< PREV PAGE NEXT PAGE >