Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 AWD V8-4.4L VIN 85 B8444S (2005)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 4029

Page 8
background image

NOTE:  Do not apply rust solvent spray or grease to the Heated Oxygen Sensor (HO2S) or combined instrument panel connectors.

-

Ignition off

-

Disconnect the battery negative terminal

-

Use compressed air to clean the disconnected connector

-

Apply rust solvent spray 1161422 to the disconnected connectors

-

Blow clean using compressed air.

NOTE:  Do not fill the protective cover with grease.

-

Press grease, P/N 1161417-9, into the terminals directly from the tube

-

Check that all the cavities in the connectors are filled

-

Use a loose male pin to ensure that contact in sockets is good. The pin should remain in position when pulled gently.

Battery, Disconnecting

BATTERY, DISCONNECTING 

Note Before Disconnecting Battery Cables 

WARNING:  The SRS (supplemental restraint system) is active for a certain time after the power is cut. Therefore wait three minutes before
starting work.
 

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 4029

[PREV PAGE] [NEXT PAGE]