Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 3
background image

Remove:

-

the M6 screw at the heat shield of the position sensor

-

the connector from the position sensor

-

the 1 M6 screw

-

the position sensor.

Installation of position sensor, cylinder 2, 4, 6 and 8 (bank 2)

Note! For tightening torques, see: Tightening torque, B8444S See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.

Install:

-

the position sensor; tighten the screw

-

the connector for the position sensor

-

the heat shield of the position sensor; tighten the screw.

Installing the upper rear engine cover

Position the upper rear engine cover and press it into place in the mountings.

Installing the upper cross stay

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Camshaft Position Sensor > Component Information > Service and Repair > Exhaust Camshaft Position Sensor, Replacing > Page 4159

< PREV PAGE NEXT PAGE >