volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 29
background image

Note! The sleeve must sit in the correct output of the pressure tool, position "Green".

Feed the end of the wire in the shrink tubing that is held by the pliers. Feed the wire into the shrink tubing until it stops, make sure that the wire
insulation does not go near the clamp on the sleeve or the stripped wire will protrude outside the sleeve.

Sensors and Switches > Sensors and Switches - Wiper and Washer Systems > Rain Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 4529

< PREV PAGE NEXT PAGE >