Volvo Workshop Manuals
XC90 FWD L6-3.2L VIN 95 B6324S5 (2011)
Brakes and Traction Control > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Technical Service Bulletins > ABS/TCS - DTC BCM 0121/C006364 Diagnostic Tip > Page 3755
^ Check all cable harnesses and connectors for the wheel speed sensors the BSC the Steering wheel Angle Sensor or Steering Wheel Module
(SAS/SWM), and the BCM. Check for contact resistance and oxidation.
^ Make sure that the wheel alignment is within specification.
^ Are there any loose or worn out suspension components?
^ Calibrate the BCM on a flat surface according to VIDA.
^ Make sure that the wheel speed sensors are in the correct position and that the sensors are not dirty or have any metallic particles on them.
^ Inspect the tire, are they all the same brand, type and dimension? Is the tire circumference the same on all four tires?
^ Make sure the SAS works properly.
^ While driving straight, does the SAS measure 0 degrees?
^ Is the Controller Area Network (CAN) working properly?
Do NOT replace any parts unless these fault tracing steps have been followed. If no problems have been found following these fault tracing steps,
|[PREV PAGE] [NEXT PAGE]|