Volvo Workshop Manuals
XC90 FWD L6-3.2L VIN 96 B6324S2 (2010)
Maintenance > Service Reminder Indicators > Maintenance Required Lamp/Indicator > Component Information > Service and Repair > Resetting The Service Reminder Indicator (SRI) > Page 1312
Maintenance Required Lamp/Indicator: Service and Repair
Ignition modes [Vehicles equipped with Remote Key]
Various ignition modes are accessed by inserting the remote key into the ignition slot. The remote key can be removed from the ignition slot by pressing
The brake pedal must not be depressed when accessing ignition modes I or II
Ignition mode 0
Insert the remote key in the ignition slot.
Ignition mode I
Press the remote key into the ignition slot and press START/STOP ENGINE.
Ignition mode II
Press the remote key into the ignition slot and press START/STOP ENGINE for approx. 2 seconds.
Ignition mode III (engine start)
Start the engine
Before starting the engine, check that the seat, steering wheel and mirrors are adjusted properly. Make sure the brake pedal can be
2. Insert the remote key into the ignition slot. Press the key until it is drawn into the slot ‹›.
The remote key should be inserted into the ignition slot with the key blade end of the remote pointing out and the key pad facing up.
3. Depress the brake pedal ‡.
An extra mat on the driver's floor can cause the accelerator and/or brake pedal to catch. Check that the movement of these pedals is
4. Press and release the START/STOP ENGINE button. The autostart function will operate the starter motor until the engine starts.
The starter motor operates for a maximum of 10 seconds. If the engine has not started, repeat the procedure.
‹› On vehicles with the optional keyless drive, it is only necessary to have a remote control in the passenger's compartment.
Always remove the remote key from the ignition slot when leaving the vehicle, especially if there are children in the vehicle.
|[PREV PAGE] [NEXT PAGE]|