XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Carefully detach the D-post panels on the right and left-hand sides. Start at the top edge then pull down until the three clips release
-
If the car has D-post loudspeakers: disconnect the connectors for the loudspeakers.
Illustration A
-
Locate the 13-pin connector at the right-hand tail lamp
-
If the 13-pin connector is connected to the towbar wiring connector: disconnect the connectors from each other.
Illustration B
-
Take the cable harness from the kit
-
Connect the 13-pin connector for the cable harness to the existing connector at the right-hand tail lamp. Connect the other connector to the towbar
wiring (if applicable)
-
Connect the green connector (1) to the RSE system if this is installed in the car.
-
Route the long single cable through the hole under the foam rubber to the battery
-
Continue to route the cable along the existing cable harness behind the battery and on through the hole under the foam rubber, into the left-hand
tail lamp
-
Continue to route the cable together with the existing cable harness along the left-hand D-post up to the roof