XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Remove the two screws (2) from under the panel
-
Carefully pry off the door panel using the weatherstrip tool. Start at the lower edge and pry opposite the clips (3).
-
Disconnect the connector (1) from the door control module and from the existing loudspeaker
-
Remove the wire (2) from the door opener handle (3). First bend up the catches
-
Remove the panel
-
Carefully remove the moisture inhibitor (4) at the front edge. This is carried out to install the nuts on the inside when installing the loudspeaker.
-
Drill out the rivets (5) holding the loudspeakers. Use a 6 mm (1/4" ) diameter drill bit
-
Remove the loudspeakers and any rivet swarf from the holes. Remove the rivet sections from the door if necessary.
-
Screw the new loudspeaker into place using the screws, washers and the nuts from the kit (1). The washers must be positioned under the screw
heads
-
Reinstall the moisture inhibitor
-
Connect the connectors (2) to the loudspeaker and the module for the door controls
-
Reinstall the mechanical cable (3) on the door opener handle (4)
-
Reinstall the door panel, and the upper panel for the door handle.
Loudspeaker, Rear Side Door, Replacing