volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Towbar Wiring, 7-Pin|Page 22596 > < Towbar Wiring, 7-Pin|Page 22594
Page 3
background image

If the SRS warning lamp lights after repairs have been carried out, take the car to an authorized Volvo workshop.

Supplemental restraint system module, SRS

C30/S40(04-)/V50/S60/XC60/C70(06-)/V70/XC70/S80/XC90

The supplemental restraint system module (SRS) is located on the tunnel under the centre console, in front of the parking brake.

Warning! The ignition must be in position "0" and the key removed from the ignition switch if any connector in the SRS system is to be
unplugged. Then wait at least three minutes and disconnect the battery negative lead before unplugging any of the connectors. When work is
completed, the ignition key must be turned to position "II" before reconnecting the battery negative lead.

Cable harness kit for towbar, 7/4-pin

Illustration A

-

Install the trailer connector with the four screws and the nuts. Tighten.

-

Pull the cable harness out towards the right along the front edge of the tow bar member.

-

Secure the cable harness with a tie strap on the sides of the tow bar member brackets.

Figure B applies to cars with R-design Skidplate

On cars with Skidplate, the contact shall be turned 90° counter-clockwise in relation to the placement in Figure A.

Towbar Wiring, 7-Pin|Page 22596 > < Towbar Wiring, 7-Pin|Page 22594