XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Ignition off.
Remove:
-
the door panel, see Panel front side door, replacing See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair.
-
the nut and screw holding the door module in place.
-
the connectors.
Pull up the rear edge of the control module.
Pull the control module backwards and upwards.
Detach the control module from the mounting on the door panel.
Press up the control module.
Disconnect the catches. Lift the upper panel from the control module.
Note! Check that the control module's connectors are intact.
Installing the driver door module (DDM)
Install the upper panel.
Position the control module in the hole on the door panel.
Check that the lower mounting for the control module is correctly located in the support on the door panel.
Press the control module into place.
Install:
-
the connectors
-
the nut and screw.
-
the door panel, see Panel front side door, replacing See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair.
Ordering software
Order software for the driver door module (DDM). See: Testing and Inspection/Programming and Relearning/Software Downloading
