XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Body Emblem: Service and Repair
Badge rear, replacing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the badge
Heat the badge carefully. Use a hot-air gun.
Carefully lift up one edge of the badge.
Caution! Do not damage the vehicle paintwork.
Remove:
-
the badge
-
any tape residue.
Installation
Installing the badge
Ensure that the vehicle is at least at room temperature (above 20 °C).
Wash the area for the badge. Use a mixture of 50% isopropanol and 50% water.
Wipe dry using a clean lint-free cloth or similar.
Caution! In order for the badge to secure, the surface must be clean and free of dust and grease.
Remove the backing from the tape.
Note! Leave the foil in place.
Guide the badge into the position indicated in the dimensions. Press the whole badge to ensure the tape is in good contact with the base.
Use the following measurements: