XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to all models
-
Drill out the nine countersink markings in the skid plate. Use an - 8 mm (5/16") diameter drill bit. Drill in the centre of the countersinks.
-
If necessary, even off the edges using a small round file.
Applies to all models
-
Clean the section of the bumper surface that will be covered by the skid plate.
Illustration A
Note! Two people are required for this operation.
-
Align the skid plate at the sides by holding it in position so that it is aligned with the embossing at the exhaust pipe. If the car has a towbar, the
skid plate must be aligned symmetrically with the vertical mounting brackets for the towbar.
-
Align the skid plate vertically so that the embossing is at the same level as the embossing on the bumper seen from immediately behind.
Illustration B
-
Accurately mark the holes for the screws by pressing through the holes in the skid plate using a pointed tool
-
Remove the skid plate. First drill out the holes. Use a - 6 mm (15/64 ") diameter drill bit. Then enlarge the holes using a - 12.5 mm (1/2")